Kaserne > Bildergalerie

Sgt. Screams Malecke für moderne Armeen - Einblick in meine unzähligen Projekte

<< < (36/42) > >>

Sgt. Scream:
It took me ages to finally find a copy of the Warrior Model 1/72 scale vacu-formed/resin kit of a NanChang Q-5 on ebay. This one came to me from a guy in Poland.

The Q-5 is a close air support/ground attacker aircraft, currently deployed by both, PLAAF (Chinese Air Force) and the PLA Navy.

This one is my first vacu-formed kit that I am ever going to assemble. That means its going to be interesting...   :blink_1:

If you look at the box contents, you\'ll see that the main fuselage and wings are vacu-formed white plastic, while weapons, cockpit and parts of the landing gear are either resin cast or white metal. The metal parts I won\'t need for the most part since I am going to assemble the kit \"in flight\" on a flight stand. I am also planning on exchanging the resin cast FAB-250 bombs with plastic ones from Dragon Models\' Soviet Aircraft payload kits in 1/72 scale. I might also use my Dream Model chinese LGBs to put them under the wings instead of the 57mm rocket pods. The modern Q-5 can carry up to two of them.

Check out the pics:

Contents: decals, instructions, painting guides, resin payload and detail parts, white metal landing gear etc..


Box: includes one kit, several decals for both, PLAAF and Pakistani Air Force

ModernCombatScale72:
Die AAVP7A1 Panzer sehn ja mal verdammt geil aus, die Bilder sind mir irgendwie durch die Lappen gegangen. Ist ja schon eine Weile her. Hast du mittlerweile mal gemalt?
Der Chinesen Bomber ist auch mal interessant, dass du auch Flieger machen kannst haben deine letzten Projekte ja bewiesen. viel Spaß ;)
Gruß Ben

SiamTiger:
Superbes Projekt. Tolle Auswahl an Figuren, breites Spektrum. Schick :)

Habe es auf WarSeer gesehen,find es top dass es aus Deutschland kommt.

Sgt. Scream:
ne, die Amtracks sind noch nicht recht viel weiter bemalt... :whistling:


Following a few guides on the internet on modelling vacu-form kits, the first steps I took was using a black marker and draw it around the parts in an 45° angle. I tried to mark 50% of both, the actual parts and the styrene sheet around it.


I then used scissors and hobby knife to cut out the parts. I tried not cut too close to the parts before they have been freed of the styrene sheet left overs around it. Next step will be cutting them out very closely using my hobby knife and then the sanding process will kick off.

Sgt. Scream:
Today I have sanded the first parts of the Fantan. I started with something small to try it and so the smaller rear wings were first to go.


The first pic shows the already sanded parts for the left rear wing. Above those you can see how the parts were looking like on top and from underneath before sanding.


After sanding them with 120 grid and 180 grid sand paper, they became really thin but to my surprise still very stiff.



At first I thought the wings will be hollow on the inside but after sanding it became clear that the two halves will have a large surface to put glue on top.

Tomorrow the sanding process will continue and I might already have a wing or two show off with. :-)

Navigation

[0] Themen-Index

[#] Nächste Seite

[*] Vorherige Sete